Jump to content
  • Sign up and share your ski reports and experiences

    SlopeEdge is dedicated to getting you up close and personal with skiing and adventure. We are mountain sports lovers like you taking photos, recording video and writing about our experiences up in the slopes. So let all this eye-candy get you excited! Or better yet, share your experiences and adventures with us on our forums. Click below to sign up now, it's free, quick and easy.

New to Snowboarding


Recommended Posts

Good day,

I was wandering how I could put my snow back into shape : a good wax, sharpen the sides and the varnish on top.

I came back from Lake Louise a couple months ago and had to send my snowboard by greyhound. The sticker they put on the top of it, ripped some of the clearcoat when I took it off.

Preferably, to be done myself of course.


Link to comment
Share on other sites

  • Replies 2
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Hello Frédéric,

Great question. You can definitely wax and sharpen your board yourself. We actually made a video last season showing how to do skis yourself (the idea and procedure is mostly the same for snowboards). You can check it out here : http://www.slopeedge.net/how-to-of-skiing/how-to-tune-your-skis-at-home . One of the great benefits of doing it yourself is that you can tune it up more frequently than you would otherwise do bringing it to the shop and save yourself alot of money.

In regards to your question on restoring the clearcoat on the top of your board, it's not something that is usually fixed. However alot of people have resurfaced the top of their board (either due to scratches or light damage, or if they wanted to change the design/graphics or colour). There isn't an official guide on this but the general procedure people follow is:

  • Preparing your board - Removing bindings, using rubbing alcohol to clean, then air dry. Sand the board using a fine-grit sandpaper.
  • Painting your board - Most people recommend automotive spray paint for this.
  • Finish off with a clear coat spray to add a layer of protection.
  • Reinstall your bindings.

Again, this should be considered an advanced job as you could easily do damage to your board. I'd only say to tackle it if you were really unhappy with the condition of your board if the sticker removal caused heavy damage to the surface. I'd always try rubbing alcohol or Goo-gone remover to see if that doesn't fix the issue before attempting this.

There's probably a Youtube video out there that shows this process in action. 

Hope this helps. Let us know how things go.

Link to comment
Share on other sites

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now

  • Create New...